Bob Smith Industries SUPER-GOLD+ POCKET Foam Safe CA w/Pin in Cap (3/4oz)
Pocket CAs are available in 3/4 & 4 oz. sizes and feature a top that has a pin built into the cap that covers the nozzle. This pin seals the bottle so that if it is tipped over, the bottle will not leak. This makes the Pocket CAs ideal for keeping in your tool or field box, just like our IC-Gel. This pin also helps prevent the clogging of the nozzle. One disadvantage that the new Pocket CA top has is the bluntness of the nozzle. This makes it more difficult to apply small amounts of the CA, especially in tight places. BSI's #304 extender tip can be used on the nozzle for finer applications. The Pocket CAs are available with BSI's Insta-Cure, Insta-Cure+, Maxi-Cure and Super-Gold+.
About:
SUPER-GOLD Thin and SUPER-GOLD+ gap filling medium thickness are our odorless foam safe CAs. They are non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+. There are no fumes that irritate the nose and eyes. The SUPER-GOLD's do not attack white foam; therefore, they can be used in the building of foam core wings and the assembly and repair of plastic and foam ARF's. They will not fog clear plastic. SUPER-GOLD+ is ideal for attaching clear canopies in plastic model kits; however, MAXI-CURE is still recommended for assembling the rest of plastic kits. Wood can be bonded to white foam with SUPER-GOLD+ in less than fifteen seconds. For bonding foam to foam, spray a very light fog of INSTA-SET to one piece and apply SUPER-GOLD+ to the other before joining. Excess INSTA-SET may create too much heat, which can melt the foam. Both SUPER-GOLD's cure to a more flexible consistency for better shock absorbtion. Whenever a large amount of CA is to be used in such applications as saturating fiberglass or Kevlar, SUPER-GOLD eliminates the irritating fumes from the evaporating monomer that make repeated use of CA unpleasant at times.
Works Best On:
Works Good On:
- Balsa Wood
- Soft Wood
- Hard Wood
- Glass & Metal
- Fiberglass
- Ceramics
- Hard Plastics
- Laminating
- Water-Resistant
- Reinforcing
- CA Hinges
Directions:
Unscrew top from nozzle. For finer applications, use the extender tip. Apply Super-Gold+ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set accelerator must be used when bonding two pieces of foam together. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220ยบ F. Soak extender tip in acetone for cleaning.
